Configuration And Operation - PATONA WB1-11 Bedienungsanleitung

3. Housing dimensions

4. Configuration and operation

4.1. Start and stop charging station with your charging card
A) Start charging process
1. Plug the charging cable into the charging port of your car. The LED ring light
on the Wallbox should now light up yellow.
2. Hold your charging card (RFID card) in front of the Wallbox reader within 3-5
seconds.
3. You will hear a beep and the LED ring light will pulse green as soon as the
charging process starts.
B) End charging process
1. Hold your charging card (RFID card) in front of the reader again for approx. 3
seconds.
2. A beep sounds again, the LED ring light lights up green when the charging
process is completed.
3. Disconnect the charging cable from your car and reattach the charging cable
to the cable holder.
C) Resetting the "Total" display
1. Press the red emergency stop button on the wallbox three times.
- 14 -