Installation; How To Use - Xiaomi Mi 2 Ultra Benutzerhandbuch

Installation

Remove Protective Coverings
Before using the vacuum-mop, remove the protective strips from both sides.
Install the Side Brush
Insert the side brush into the attachment slot on the bottom of the vacuum-
mop.
Side Brush Clip
9
Place Charging Dock Against Wall and Charge
· Place the charging dock near an electrical outlet in an area with a good
Wi-Fi signal.
Tidy up loose cord as shown in the figure to prevent the vacuum-mop
·
from getting tangled, which could accidentally move or unplug the
charging dock.
Place the vacuum-mop onto the charging dock. The vacuum-mop will
·
automatically turn on and begin charging.
After 10 minutes of the full charge of the battery, the indicator goes off.
·
Tidy up Any Loose Cord
> 1.5 m
Notes:
· Fully charge the vacuum-mop before using it for the first time.
· The vacuum-mop will remain on while connected to the charging dock.
· When the vacuum-mop is left at the dock, it will consume a small amount of electricity to
allow the battery to maintain optimal performance in sleep mode.

How to Use

Connect with Mi Home/Xiaomi Home App
This product works with the Mi Home/Xiaomi Home
app*. Use the Mi Home/Xiaomi Home app to control
your device, and to interact with other smart home
devices.
Scan the QR code to download and install the app.
You will be directed to the connection setup page
if the app is installed already. Or search "Mi Home/ 7714C808
Xiaomi Home" in the app store to download and
install it.
Open Mi Home/Xiaomi Home app, tap " " on the upper right, and then
follow prompts to add your device.
* The app is referred to as Xiaomi Home app in Europe (except for Russia).
The name of the app displayed on your device should be taken as the
default.
Notes:
· Only 2.4 GHz Wi-Fi networks are supported.
· The version of the app might have been updated, please follow the instructions based
on the current app version.
Reset Wi-Fi
When there is a connection loss between your phone and the vacuum-
mop due to the router reconfiguration, wrong password or so:
1. Please open the cover of the vacuum-mop so that you can see the Wi-Fi
indicator.
2. Simultaneously press and hold the buttons and until you hear a
voice saying "Waiting for the network configuration".
3. When the Wi-Fi indicator blinks, the Wi-Fi connection has been reset
successfully.
Start Cleaning
Press the button , and the vacuum-mop will clean all areas by first
cleaning along edges and walls and then in an S-shape pattern. Once the
cleaning is complete, the vacuum-mop will automatically return to the
charging dock to charge.
Area 1 cleaned Area 2 cleaned
Area 3 cleaning
Area 4 to be cleaned
Notes:
· Before a cleaning task, make sure the vacuum-mop is fully charged and starts from the
charging dock. Do not move the charging dock while the vacuum-mop is cleaning.
· This cleaning diagram is for illustrative purposes only. Results may vary depending on the
actual conditions.
Resume Cleanup
If the vacuum-mop starts running low on battery during a cleaning task, it will
automatically return to the charging dock to recharge, then resume cleanup
where it left off after being charged sufficiently.
10