Display; Controls; Controls & Display - Qwic Atlas Bedienungsanleitung

3.1 Display

The console will only switch on if the batt ery is inserted in the bike.
Switch on the display by shortly pressing the 'ON/OFF' Butt on, located
on top of the console.

3.2 Controls

Adjusti ng the pedal assistance
Use the ' ' and ' ' butt ons to change the assistance level. A higher
assistance level means more assistance from the motor. Power level 0
provides no pedal assistance but allows you to sti ll use the display of the
e-bike. Please note that the batt ery uses power faster when using a high-
power level compared to a lower power level.
Operati ng the walk assist
Enable the walk assist functi on to get assistance while walking next to
your bike. Keep the 'WALK' butt on pressed (3 seconds) while fi rmly
holding the handlebars. Please keep at least one hand on the brakes.
Aft er a few seconds, the motor will start providing assistance. As soon
as you release the 'WALK' butt on, the walk assist functi on automati cally
switches off . Walk assist has a maximum speed of 6 km/h (without load).
Selecti on fi eld
Briefl y press the 'WALK' butt on to switch between speed and range.
USB connecti on
The USB port on the back of the display can be used to provide power
to devices such as smartphones and navigati on devices. The USB port
can also be used when the bike is switched off (as long as the batt ery is
inserted). Maximum charging current at 800mAh.
36
Failure
Lighti ng
indicator
On/ Off
Assist up
Range:
Indicated km
left to drive
Assist down
Walk assist
Batt ery
indicator
Errors
If an error occurs, please refer to page 49 for soluti ons.
Reset
You can reset the display by removing the batt ery from the bike and
pressing the on/off butt on for a few seconds. This causes the residual
current to leave the system. Aft er you have done this you can put the
batt ery back in the bike and turn it on.
3. CONTROLS & DISPLAY
Bluetooth
Connecti on
Speed:
km/h or mph
Assistance level