Connection; Maintenance And Care; Warranty; Disposal - led2work PROFILED AC Betriebsanleitung

BA PROFILED AC

5 | Connection

The luminaire is connected with a 220–240V AC electric power supply system via the cable with SCHUKO plug.
1
PROFILED DC, luminaire without dimming
To turn on the luminaire, activate the switch on the side of the luminaire body and set it to [ I ].
2
PROFILED DC, luminaire with dimming
To turn on the luminaire, activate the push button on the side of the luminaire body. Hold on the push button for setting
of the light intensity. A repeated pushing of the button turns the light off.

6 | Maintenance and Care

The LED luminaire is maintenance-free. Do not make any alterations to the luminaire (except according to the mounting
information contained in this manual).
The LED light sources mounted in the luminaire are connected to the luminaire housing in a special way (thermal cou-
pling) and may react sensitively to electrostatic discharges (ESD). That is the reason why repairs may only be carried
out by the manufacturer or by persons authorised and qualified by the manufacturer.
Turn off the light before cleaning and let it cool down completely. Clean the outside of the luminaire with a soft, dry and
clean cloth. To remove excess dirt, moisten the cloth with water. Never use aggressive cleaning agents, as these may
cause discolouration of the housing.

7 | Warranty

We supply a full warranty for the product for 36 months from the date of purchase. This warranty applies for fault-free
working under proper use and in accordance with the operating instructions.
During the warranty period defects and faults in the product will be rectified free of charge if they are proven to be
caused by material, processing or design errors. If the purchaser complains of a material defect, he bears the burden of
proof to demonstrate that the product was already defective upon receipt.

8 | Disposal

Do not open the luminaire!
No liability is assumed for damages resulting from the use of unsuitable cleaning agents.
The warranty does not extend to defects caused by wear, negligence or improper use.
Further claims, in particular claims for compensation for damage that did not occur on the
LED luminaire itself, are excluded.
The luminaire must be disposed of at a suitable disposal site designated
for recycling of electrical and electronic equipment in accordance with
local, national regulations. (WEEE-Nr. 32828318)
www.led2work.com | shop.led2work.com | 9