For Safe Operation; Safety Information; Assembly/Mounting - led2work PROFILED AC Betriebsanleitung

2 | For safe operation

The operating parameters of the LED luminaire specified on the type plate must correspond to the supply parameters of
the connection.
Operate the luminaire only in a mounted status.

3 | Safety information

4 | Assembly / Mounting
Check the LED luminaire before installation to ensure it is complete and shows no signs of damage. Do not use the
luminaire or accessories if they are damaged, as there is a risk of injury.
The LED luminaire comes fully assembled. It is preferably mounted on a T-slot profile. As option there are this mounting
accessories:
Mounting kit, flat, for T-slot, with ESD insulation (Electro Static Discharge), pair
Mounting kit, pivotable, for T-slot and movable mounting, pair
Mounting kit, one pair of T-Slot Nuts with cheese-head screws
8 | BA PROFILED AC . BA 03/2022
Under no circumstances may the luminaire be covered with cloths, foils or similar. Object
distance the light-emitting surface should be at least 10 cm.
During the operation of the luminaire in a 220-240V power supply net, it could be the cause,
that machines (induction perpetrators) inside the same power supply net cause interference
spikes at start. This deviations may only 10% max.
Hot plugging should be avoided, since this can lead to the destruction of the LED luminaire.
Installation of electrical equipment may only be carried out by qualified electricians.
Follow the five safety rules according to DIN VDE 1005. Failure to do so may result
in damage to the LED luminaire, as well as fire or other hazards.
Danger of electric shock!
Disconnect before working on the device or load. Ensure to disconnect all circuit breakers
that supply dangerous voltages to the device or load, when doing so. Even when the
device is switched off, the load is not galvanically isolated from the mains.
Only use the device if it is completely free of faults, and with safety and awareness in
mind. If warnings or symbols are attached to the luminaire, they must not be removed.
When mounting the luminaire, make sure that the luminaire is fastened securely and
stably. If the luminaire falls down, its weight poses a risk of injury!
Product no.
240400-01
240400-02
240400-03