Revopoint 3D Technologies POP 2 Gebrauchsanleitung Seite 12

POP 2 3D Scanner User Manual
④ 3D Model
Preview Window:
⑤ Tool bar：
Icon : Reset the view of the model to the default position in the 3D Model Preview Area. This is determined by
the first scanned frames of the object.
Icon : Hide or show the background in the 3D Model Preview window.
Icon : Switch between Color/No-color point cloud data.
Note: If No Color was specified in the New Scan configuration popup, the icon is displayed as locked (
⑥ Scanning
Distance:
⑦ Exposure and
Gain adjustment:
⑧ Timer：
⑨ Function Buttons:
Icon / :
Icon :
Icon and :
Mesh :
Texture :
Export :
� The text icon" Save The Settings" is used to keep the Scan Settings in New Scan and Parameters in Scanning UI.
� �
necessary to untick this option.
Displays the 3D model data that will be captured when scanning starts or all of the data that has
been captured after scanning has started. The view of the model may be dragged or zoomed in
the 3D Model preview area by the mouse (Left Mouse Button: Rotate the model; Wheel: Zoom
in/out).
Too near, Excellent, Good, Too Far. ~
Placing the POP/POP 2 or the object to be scanned so that it is in the Excellent zone will have
the best balance of resolution and tracking. Adjust the optimal distance according to the prompt.
Higher-resolution scans can be made in the "Too near" range, but it is more likely that tracking
will be lost.
Brightness and Gain (the sun icon
displayed in red will return point cloud data while scanning). Some Scan Modes allow for
Automatic adjustment to find the best setting, but remember to switch to Manual before
scanning to prevent exposure variations that interfere with data capture.
Count down from an arbitrary number (default is 3 seconds) to indicate the time remaining
before scanning.
Start or pause scanning.
Stop the current scanning project. A popup will allow choosing between completing the scan
(fusing the Point Cloud) or deleting the entire project to start over from Step 1 on p. 2.
Undo or Redo several scanned frames of the model at a time.
Maps the scanned 3D point cloud data into planes or triangles.
If "No Color" was selected when the Scan Mode was defined, the model only consists of point
cloud and mesh information.
If the "Color" option was selected, then the model will also contain the color information of
each point.
Match pixels of the picture on the mesh model to improve the texture and color resolution.
Export the completed 3D model.
) can be manually adjusted for best results (the areas not
10
COPYRIGHT ©2022 REVOPOINT 3D ALL RIGHTS RESERVED
).