Angle Attachment; Switching The Led Light On/Off; Belt Clip; Bit Adapter - Mafell A18 Originalbetriebsanleitung

heard while doing so) until it is not possible to turn
any further - only now the tool is reliably tensioned.
In case of a soft tool shaft, it may be necessary to
retension after a short drilling time.
Notes on ASB18 M and A18
•
The ratchet sound that may be heard after
opening the chuck (functional) is switched off by
counter-rotating the sleeve.
Cleaning: Hold the machine occasionally with the
quick-release chuck pointing vertically down and turn
the sleeve completely in direction
completely in direction
out of the quick-release chuck.
5.8.2 Quick-release bit holder
Inserting a bit: Slide the bit into the bit holder until it
audibly engages.
Removing a bit: Pull the sleeve at the bit adapter
forward until it engages and remove the bit.
The quick-change bit holder can be
used for screwing applications with
up to 8 mm countersunk screws in
wood or up to a torque of max. 60
Nm.
In the event of higher requirements,
insert the bit directly into the
spindle or use the chuck.
5.8.3

Angle attachment

The angle attachment can be used to work at right
angles to the screwdriver axle.
Slide the angle attachment completely onto the
machine until the components' profiles engage.
Adjust the clamping force at the adjusting screw (19)
(Fig. 6).
Forcefully push the clamping arm (18) down to the
limit stop, in this manner fastening the angle
attachment on the machine (Fig. 6).
If the angle attachment is not slid
onto the clamping collar, the lever
may not be pushed forcefully down.
Failure to do so can destroy the
tight fit.
and then turn it
. The collected dust drops

5.9 Switching the LED light on/off

•
Press the switch trigger (12) to switch on the
LED light (7).
•
After releasing the switch trigger (12), the LED
light (7) still glows for approx. 5 sec. and then
switches off.

5.10 Belt clip

For an easier handling of the belt
clip, remove the rechargeable
battery (see chapter 5.2)
(see Fig. 4)
Detaching:
•
Press the belt clip (6) together at the rear.
•
Swivel it out of the rear opening.
•
Slacken the belt clip and remove it from the front
opening.
Attaching:
•
Press the belt clip (6) together and insert it into
the openings provided.
•
The belt clip (6) can be attached on both sides.

5.11 Bit adapter

(see Fig. 1)
A screw bit can be fitted in the bit adapter (5) on both
sides.

5.12 Optical alignment (spirit level)

The bubble level (14) and circular level (15) can be
used to align the screwdriver in horizontal and vertical
direction.
6

Service and maintenance

Danger
Unplug the rechargeable battery for
all service work.
MAFELL machines are designed to be low in
maintenance.
Always keep the appliance clean.
Should the appliance
manufacturing and testing procedures, the repair
-22-
fail despite thorough