Installation Steps - Zolia CLARA Bedienungsanleitung

INSTALLATION STEPS

Open the battery compartment, insert two AAA
batteries, and tighten the screws to fix the battery
compartment.
Install the funny cat connecting rod on the transmission shaft to complete the installation.
Gently press the transparent button to open
FREQUENTLY ASKED QUESTIONS AND SOLUTIONS
Q : How many colors and modes are there for toy lights ?
A : The white light is in the auto-rotating funny cat mode, the red light is the standby mode. In this mode, it is
switched to the auto-rotating cat mode when the external vibration signal is received. If the light is off, it is off.
Q : Why can't the toy start after installing the battery ?
A : Generally, it is caused by the reversed polarity of the battery or the battery is dead. Please replace the battery
and install the battery according to the instructions.
Q : Why does the rotation speed of the toy slow down ?
A : Generally, the battery power is insufficient or the voltage of the rechargeable battery is not enough. It is
recommended to replace the two 1.5V AAA batteries.
Q : Why does the toy show that the indicator light does not light up, but the motor is spinning ?
A : Caused by insufficient battery power and attenuation of voltage. It is recommended to use two 1.5V AAA
batteries. Rechargeable batteries are not recommended.
Q : What should I do if the toy suddenly shuts down during operation ?
A : No need to panic. This is the activation of the toy's internal intelligent system, which will automatically shut
down the toy to save electricity. The intelligent system will automatically turn off the toywithin about 13 minutes if
it senses that the toy is inactive.
Hold the connection between the base and the grain
storage tank with both hands, rotate to the
corresponding position of the arrow, unscrew the
grain storage tank, load the appropriate amount of cat
food, and tighten it.