Cleaning And Maintenance; En - Cat Toy Clara - Zolia CLARA Bedienungsanleitung

Thank you for buying one of our Zolia products. We hope that it will give you full satisfaction.
PART NAME

CLEANING AND MAINTENANCE

● Before cleaning, the power must be turned off.
● Wipe the surface directly with a towel or paper towel. Do not use water, gasoline, alcohol or other liquids to
directly rinse the product.
● The inside of the grain storage tank needs to be cleaned regularly and placed in a dry and ventilated place to
dry to prevent the growth of bacteria.
CAUTIONS
➔ This product is for cats only, please use it in the indoor environment, please do not droop or bump it, so as to
avoid damage.
➔ Regularly check toy accessories, make sure to install the accessories in place before use.
➔ There are precision electronic components inside this product, except for replacing the battery, please do not
disassemble it artificially to avoid damage to the device.
➔ This product has a smart sensor, about 3 minutes after turning on, if the toy senses that there is no cat playing,
it automatically enters standby, the power light flashes red. If you want to continue to use it, just touch the toy.
No operation in standby mode, the toy will be automatically shut down in about 10 minutes.
➔ Observe the playing of pets, if you find pets biting or disassembling the toy, please correct the pet's behavior in
time to avoid electricity leakage, accidental eating or damage to the toy.
➔ Please pay attention to the changes of food in the grain storage tank when using and make changes, increase
or decrease in time according to the situation.
➔ When using this product, two AAA batteries of No. 7 need to be installed.
➔ This product has no waterproof function. If you need to clean it, please wipe the surface with a towel or paper
towel. Do not rinse with water to avoid short circuits of internal components.

EN - Cat Toy CLARA

A - Funny cat connecting rod
B - Transmission shaft
C - Grain storage tank
D - Cat food outlet
E - Battery compartment
F - Wine bottle base