Parts Description - Makita DHG180 Betriebsanleitung

14. During and after use, the battery cartridge may
take on heat which can cause burns or low
temperature burns. Pay attention to the han-
dling of hot battery cartridges.
15. Do not touch the terminal of the tool imme-
diately after use as it may get hot enough to
cause burns.
16. Do not allow chips, dust, or soil stuck into the
terminals, holes, and grooves of the battery
cartridge. It may cause heating, catching fire,
burst and malfunction of the tool or battery car-
tridge, resulting in burns or personal injury.
17. Unless the tool supports the use near
high-voltage electrical power lines, do not use
the battery cartridge near high-voltage electri-
cal power lines. It may result in a malfunction or
breakdown of the tool or battery cartridge.
18. Keep the battery away from children.
SAVE THESE INSTRUCTIONS.
CAUTION:
Only use genuine Makita batteries.
Use of non-genuine Makita batteries, or batteries that
have been altered, may result in the battery bursting
causing fires, personal injury and damage. It will
also void the Makita warranty for the Makita tool and
charger.
Tips for maintaining maximum
battery life
1. Charge the battery cartridge before completely
discharged. Always stop tool operation and
charge the battery cartridge when you notice
less tool power.
2. Never recharge a fully charged battery car-
tridge. Overcharging shortens the battery
service life.
3. Charge the battery cartridge with room tem-
perature at 10 °C - 40 °C (50 °F - 104 °F). Let
a hot battery cartridge cool down before
charging it.
4. When not using the battery cartridge, remove
it from the tool or the charger.
5. Charge the battery cartridge if you do not use
it for a long period (more than six months).
PACKAGE CONTENT
LIST
Check that the items listed below are included in the
package.
• 1 Cordless Heat gun
• 1 Set of accessories (Some accessories may not
be necessary depending on your purpose.)
• 1 Instruction manual
NOTE: When parts are missing or damaged, please
contact your dealer.

PARTS DESCRIPTION

► Fig.1
1 Heating nozzle
3 Lock off lever
5 Lock on button
7 Hook
9 Air volume switch (1/2)
ASSEMBLY
Attaching and detaching
accessories
The heat gun can use with accessory or without the
accessories according to various of heating purpose.
Attaching the accessory
— Choose the appropriate nozzle according to the
heating applications.
— Push the fitting end of the nozzle onto the heating
nozzle.
MOUNTING THE CORRECT
ACCESSORY (IF APPLICABLE)
Shape and
description
Glass protection
nozzle
Protect windows
when stripping
frames
Wide-slot nozzle
For heating spread
over wider area
Reflector nozzle
8 ENGLISH
2 Front cover
4 Switch trigger
6 LED light
8 Hook release button
10 Temperature dial
Example
Drying the putty on the window flame
Removing putty from the window frame
with the scraper (optional accessory)
Heat packaging for heat shrink films
Heat shrinking for heat shrink tubes
Bending of resin tube