Electric Motor Installation - Horizon Hobby HANGAR 9 Tiger 30cc Bedienungsanleitung

102. Secure the receiver battery in the fuselage.
103. Remove the covering for the switch using a hobby knife with
a #11 blade. Use the opening that best fi ts the switch for your
radio system. Secure the switch in the side of the fuselage.

ELECTRIC MOTOR INSTALLATION

104. Use a drill and 13/64-inch (5mm) drill bit to drill the
appropriate holes for the engine mounting screws.
EN
105. Attach the motor box to the fi rewall using four M5 x 25 socket
head cap screws, four M5 washers and four M5 fl anged nuts.
106. Draw the blind nuts into the back of the motor box using an
M4 x 25 socket head cap screw and M4 washer. Install all
four blind nuts at this time.
107. Attach the motor to the motor box using four M4 x 25 socket
head cap screw and four M4 washer. Place a drop of thread
lock on the treads at the end of each screw before installing
them. Tighten the screws using a 3mm hex wrench.
108. Solder any necessary connectors and extensions in
preparation for the speed controller installation. Attach the
speed controller to the motor box where it won't interfere
with the cowling or operation of the motor.
16