Installation; Supplied Components; Start-Up; Turning On And Off - XS Instruments OXY 7 VIO Betriebsanleitung

Installation

 Supplied components
The instrument is always supplied inside the specific carrying case with these accessories.
batteries, standard 0 oxygen, paper tissues, screwdriver, beacker, multilingual user manual and test report.
Contact your local distributor to be updated on the correct composition of the sales kit.
 Start-up
 The device leaves the factory ready to be used by the user.
 Batteries are included.
 Turning on and off
Turn on the system by pressing the button
appears:
Model and firmware of the instrument.

 Settings relating to the most important parameters.
Nota: every time the instrument is turned on after use, automatically the Polarization Time will start (next
Paragraphs).
 Replacement of batteries
The instrument works with 3 AA 1.5V batteries. To proceed with the replacement:
1. Turn off the device.
2. Turn the instrument over with the display facing down and place it on a stable surface.
It is advisable to put a cloth to avoid any scratching on display.
3. Using the screwdriver supplied, completely unscrew the screw close to the battery symbol.
4. Remove the battery stopper cap with the help of the lanyard.
5. Remove the 3 exhausted batteries and insert the new ones. Pay attention to the correct polarity. Follow
the diagram above the battery symbol in the rear compartment of the instrument.
6. Reinsert the battery stopper cap; always hold it with two fingers, insert the screw and tighten.
 Instrument transportation
The instrument is always supplied with the appropriate carrying case. Use the original case only, to transport
the instrument. If you need to buy it again, contact your local distributor.
The interior of the case is shaped to be able to house the instrument and the sensors still connected.
UM Serie Oxy7Vio EN rev.0 28.05.2020
. The display initially activates all segments and then
9
EN