Key Functions; Inputs / Outputs Connections - XS Instruments OXY 7 VIO Betriebsanleitung

 Key functions
Button Pression Function
Press to turn the device on or off.
Short
In measure mode, press to scroll through the different parameters:
Short
 OXY 7 Vio: % O
 In calibration mode, press to return to measure mode.
Short
 In measure mode, press to start the calibration.
In measure mode, press to enter the setup.
Short
In the setup menus, press to select the desired program and / or value.
During calibration, press to confirm the value.
In the setup and subset menus press to scroll
Short
In the setup submenus, press to change the value
In MTC and customer calibration mode, press to change the value.
In measure mode, keep one of the two keys pressed to change the temperature
in MTC mode (manual compensation, without probe). When the value starts to
Long-press
flash, the user can change the temperature value by entering the correct one and
(3s)
confirming with
IMPORTANT:
 When the Sleep mode is active (by default after two minutes of inactivity of the instrument) press
any key to reactivate the brightness of the display.
Only at this point do the keys regain their function.

 Inputs / Outputs connections
Use original accessories guaranteed by the manufacturer only.
If necessary, contact your local distributor. The BNC connectors are protected by a plastic cap.
Remove the cap before connecting the probes.
RCA for temperature probe
of the polarographic sensor
READ THE MANUAL BEFORE PROCEEDING TO CONNECT THE PROBES OR PERIPHERALS
UM Serie Oxy7Vio EN rev.0 28.05.2020
 mg/l  mbar
2
.
OXY 7 Vio top panel
10
BNC for polarographic sensor
EN