Troubleshooting - BOMANN DU 7600 IX Bedienungsanleitung, Garantie

• Remove the aluminum grease filter by sliding
back the lock in the handle recess, push the filter
down gently and pull out towards the front.
• Rinse the grease filter in a solution of hot water
and neutral detergent. Soak the filter in it.
• Then clean with a soft brush, rinse thoroughly with
hot water and allow drying.
• Alternatively, the grease filter can also be cleaned
in the dishwasher (up to 65°C). Slight discolora-
tion may occur. This does not affect the function
of the grease filter.
Replacing the activated carbon filter Replacing the activated carbon filter
Replacing the activated carbon filter Replacing the activated carbon filter
The activated carbon filter prevents odors and must
depend on the use but be changed at least every six
months.
Order the carbon filter from your dealer or in our
online accessories shop,
Use the reference number found under "Technical
Data".
• See "Installing the activated carbon filter for recir-
culation mode".
• Remove and dispose the old carbon filter.
Replacing the bulb Replac ing the bulb
Replac Replac ing the bulb ing the bulb
CAUTION: CAUTION: CAUTION: CAUTION:
Do NOT NOT remove the LED lighting cover! NOT NOT
The bulb may only be replaced by an authorized
specialist in case of a defect.
WARNING WAR NING: : : :
WAR WAR NING NING
• The light of LED lamps is very bright and can
damage the eyes. Never . Never look directly into the . Never . Never
LED light!
• Disconnect the appliance from the power supply
and allow the lamps to cool down before changing
the lamp. There is a risk of burns! There is a risk of burns! There is a risk of burns! There is a risk of burns!
NOTE NOTE: : : : NOTE NOTE
Order the lamps from your dealer or in our online
accessories shop www.bomann www .bomann- - - - germany.de
www www .bomann .bomann
All manuals and user guides at all-guides.com
www.bomann- - - - germany.de www.bomann germany.de.
www.bomann www.bomann germany.de germany.de
germany.de.
germany.de germany.de
Lamp data: Lamp data:
Lamp data: Lamp data:
LED max. 1 x 2.0W, AC 12V, ILCOS D Code after
EN 61231: DBS-2/30-H-120-33
• Remove the grease filter.
or (b):
Open the black protective box of the plug-in
device and release the plug connection.
• Carefully push the lamp out of the holder.
• Replace defect LED module and connect the two
ends of the plug-in device.
• Insert new lamp properly in the bulb holder.
• Close the protective box with inserted plug-in
device. Replace the grease filter.

Troubleshooting

Troubleshooting
Troubleshooting Troubleshooting
Before you contact an authorized specialist Before you contact an authorized specialist Before you contact an authorized specialist Before you contact an authorized specialist
Problem Problem Problem Problem Possible Cause / Solution Possible Cause / Solution Possible Cause / Solution Possible Cause / Solution
Unit is not ∙ Check the power supply.
working or not ∙ Check the power level.
properly
Unit is not ∙ Check the power level.
working ∙ Is the kitchen properly ventilated?
efficiently ∙ Clean the grease filter. ∙ At recir-
culation mode, check the carbon
filter. ∙ Check the air outlet.
Light is not ∙ Check the bulb, see "Replacing
working the bulb".
Oil is dripping ∙ Clean the grease filter.
NOTE: NOTE:
NOTE: NOTE:
If you are still having problems after following steps
above, contact your trader or an authorized techni-
cian.
21
Depending on model (a)