Option 2: Setting Up The Youvi Camera Module (With Bria Solo Free) - PEAKnx 2N IP Verso Kurzanleitung

3 Setting up the VoIP communication
20. When you have added the door station module to the Dashboard, a widget with informa-
tion about registration with the SIP server will appear. If this is successful, the door station
module is ready for use.
21. To test these settings, press the door bell on your door station. The door station widget
opens on the panel:
Functions of the widget:
Before accepting the call: accept video call from the door station, reject, or open the door
■
directly
After accepting the call: make video call, open door, mute, end call, deactivate camera
■
image
Select a ringtone of 5 predefined tunes or upload a ringtone in the tile settings of the Door
■
intercom widget
Define the duration of the ring tone in the tile settings of the Door intercom widget
■
The widget closes automatically 3 seconds after the door is opened.
■
Video transmission in MJPEG, JPEG and RTSP
■

3.2 Option 2: Setting up the YOUVI camera module (with Bria Solo Free)

If you want to use only the camera module, this is possible together with free VoIP software.
However, we cannot influence any changes to conditions for the free use of this software.
1. Open the YOUVI Configuration Dashboard page via the desktop shortcut or the green
house in the taskbar.
− You can also reach the configuration page on your browser, as long as you are in the
same network as the PEAKnx touch panel. To do this, enter the following URL in your
browser:
− http://x.x.x.x:31228, Where x.x.x.x must be replaced by the local IP address of your
29