ITRON CF 800 Installations- Und Bedienungsanleitung Seite 7

Installation for a CF 800
1
Install the configured Modbus card under the
metrological block of the CF800, position option1
3
Modbus card power supply from the CF
"Supply RF" connector (2-wire long cable)
If water meters are connected to the CF 800, these meter index values are transmitted in Modbus
ON/OFF switch
2
Check proper connection of the card on the
1 x 2 points connector
1 x 16 points connector
4
Modbus output on the CF 800 terminal block
Terminal 24 = D -
Terminal 25 = D+