Use - EASYmaxx 07703 Originalbetriebsanleitung

EN

Use

PLEASE NOTE!
■ Ensure prior to each use that the openings of the compressor are clear. Keep the air
outlet opening clean.
■ The compressor is not designed for constant operation. After a maximum of 15 min-
utes of operation, switch it off for at least 15 minutes so that it does not overheat.
■ Do not overfi ll objects! They could burst. Determine the maximum pressure before
pumping them up.
■ Take the battery pack out of the compressor when it is not being used.
Charge the battery pack (5) before you fi rst use it and when the power of the compressor
diminishes (see "Charging Up the Battery Pack").
Low ambient temperatures may compromise the battery power.
1. Make sure that the contacts of the battery pack are clean.
2. Insert the battery pack into the handle (13) of the compressor (1). It must engage
audibly.
3. Attach the compressed air tube (2) to the compressor: Align the symbols
turning ring of the compressed air tube) and
one another. (Picture F) Press the turning ring onto the air outlet opening and turn it
clockwise until
4. If one of the adapters (3, 6) that is supplied with the device is required, screw it into
the thread of the compressed air tube. (Picture H)
5. Press the button
the button until the pressure unit you want (psi, bar or kPa) is displayed.
If no button is pressed for 30 seconds, the display and the LED automatically
switch off .
6. If necessary, remove the protective cap from the valve of the object that is to be
pumped up.
7. Quickly screw the compressed air tube onto the valve or plug the adapter into the
valve.
8. After it has been connected, the current pressure is shown on the display. Use the
buttons +/- (9, 8) to set the pressure you want.
9. Press the On switch (16). The compressor starts to work. Once the required pressure
has been reached, it stops automatically.
10. Press the On switch again to deactivate the compressor.
11. To switch off the display and the LED, hold down the button
12. Quickly release the compressed air tube or adapter from the valve. CAUTION: The
connectors could be hot!
13. Reattach the protective cap to the valve if necessary.
14. Unscrew the adapter from the compressed air tube and push it into the adapter holder.
07703_Inlay_DE-EN-FR-NL_A5_V2.indb 20 07703_Inlay_DE-EN-FR-NL_A5_V2.indb 20
20
points towards . (Picture G)
(10) to switch on the display (7) and the LED (12). Keep pressing
(above the air outlet opening (13)) with
for 3 seconds.
(on the
11.08.2020 14:55:17 11.08.2020 14:55:17