Charging Up The Battery Pack - EASYmaxx 07703 Originalbetriebsanleitung

q) Make sure that the cable of the mains adapter does not present a trip haz-
ard. Otherwise, there is a danger of tripping.
r) Check the connecting cable for damage each time before you put it into
operation. If you fi nd any damage or wear, do not use it to prevent injuries.
s) Keep the mains adapter which is connected to the mains power away from
highly fl ammable materials (e.g. paper, textiles etc.). There is a danger of fi re
as a result of the heating of the mains adapter which occurs during charging.
t) Do not cover the power tool and accessories during operation. Make sure
that the ventilation slots of the power tool are free of any contamination and
are not covered during use to prevent the risk of fi re.
u) Remove the mains adapter from the plug socket if a fault occurs or if a thun-
derstorm is expected. Do not use the mains adapter if it has malfunctioned
or been dropped in water. Otherwise, there is a danger of electric shock.
v) Only use and store the power tool and the mains adapter in an ambient tem-
perature of from 0°C to 40°C. This will ensure that the safety of these compo-
nents is maintained.
w) Use only original accessories from the manufacturer. The way that the pow-
er tool works could be compromised, resulting in damage. The LED cannot be
replaced.
x) Do not lay or place heavy objects on the dvice tool or the mains adapter.
y) Make sure that the cable of the mains adapter does not become squashed or bent
and does not come into contact with sharp edges or hot surfaces.

Charging Up the Battery Pack

PLEASE NOTE!
■ Charge up the battery pack fully before you fi rst use the power tool in order
to achieve the maximum charging capacity. If the battery pack is fully discharged
during use, it must be fully charged up again before it is next used.
■ Charge the battery pack only indoors in an ambient temperature of from 0°C to 40°C.
1. Remove the battery pack (5): Press both release buttons (15) at the same time and pull
the battery pack out of the handle (13) of the compressor (1). (Picture C)
2. Fully unwind the cable of the mains adapter (4).
3. Plug the barrel connector on the cable into the charging socket (14) of the battery
pack. (Picture D)
4. Connect the mains adapter to an easily accessible socket. (Picture D) The control
lamp of the mains adapter starts to light up red. (Picture E) Allow the battery pack to
charge.
5. When the control lamp is lit green, it is fully charged up.
To ensure that the battery pack has the longest possible lifespan, it should not be
connected to the mains power for longer than 5 hours.
6. First pull the mains adapter out of the plug socket and then pull the barrel connector
out of the battery pack.
07703_Inlay_DE-EN-FR-NL_A5_V2.indb 19 07703_Inlay_DE-EN-FR-NL_A5_V2.indb 19
19 EN
11.08.2020 14:55:17 11.08.2020 14:55:17