Replacing The Battery In The Remote Control - Colorlight COLORBLOCK CBLROCKS Bedienungsanleitung

7. Flash button: The light automatically flashes to the rhythm of the music.
8. Smooth button (colours change automatically): 7 colours change automatically.
9. White button: press this button to select white light.
10. Time button: When you turn on the light, the timer is deactivated and the device works continuously.
The timer feature lets you program the light and Bluetooth function to stop automatically:
- Press 1 time: red light – set for 30 minutes
- Press 2 times: green light – set for 1 hour
- Press 3 times: blue light – set for 1 hour and 30 minutes
- Press 4 times: yellow light – set for 2 hours
- Press 5 times: cyan light – set for 2 hours and 30 minutes
- Press 6 times: violet light – set for 3 hours
- Press 7 times: white light – set for 3 hours and 30 minutes
11. Previous button: When the Bluetooth function is activated and the music is playing, press this button to go back to
the previous track.
12. Next button: When the Bluetooth function is activated and the music is playing, press this button to go to the next
track.
13. Pause and Play: When the Bluetooth function is activated and the music is playing, press this button to play a track
or to pause it.
14. Volume - and + : When the Bluetooth function is activated and the music is playing, press « - « to lower the
volume or « + « to increase it.

REPLACING THE BATTERY IN THE REMOTE CONTROL

• If you are unable to activate the light using the remote control, replace the battery.
• Slide the slot located on the side of the battery housing to the right; the battery cover will lift up. Then remove the old
battery and replace it with a new one.
• When replacing the battery in the remote control, make sure to respect the battery orientation as marked on the battery
compartment.
WARNING
• Make sure the battery is inserted in the right direction and the polarity is respected.
• Remove the old battery from the device.
• Do not short-circuit the power terminals.
• Do not swallow the battery.
• Dispose of the battery in accordance with safety recommendations.
INFORMATION ABOUT THE BATTERIES (only applicable if the batteries are included)
The polarity must be respected when you insert the batteries.
The batteries must be inserted in such a way as to not cause any short circuit.
Do not use old batteries with new ones.
Do not use standard alkaline batteries (carbon-zinc) with rechargeable batteries (nickel-cadmium).
Do not expose the batteries to excessive heat, such as sunlight or flame.
Remove the batteries when they have not been used for a long time.
If the liquid contained in the batteries comes in contact with eyes or skin, immediately and carefully wash the affected areas
using clean water and consult a doctor.
The product / remote control may contain a button cell type battery.
12