Reset Function; Using The Remote Control - Colorlight COLORBLOCK CBLROCKS Bedienungsanleitung

RESET function

USING THE REMOTE CONTROL

NOTE: Start by removing the plastic film from the battery cover before performing the following operations.
1. Sleep button: After turning the speaker on (by pressing the on/off button located at the bottom the lampshade),
briefly press this button to turn the light and the Bluetooth function off, then press it again to turn the light and the Bluetooth
function back on.
Press and hold this button to turn the speaker off; to turn it on again, press the on/off button at the bottom of the lampshade.
2. Brightness and speed buttons: Adjust the speed in «Smooth» mode (colours change automatically). Modify the
brightness when the colour does not change.
3. Light activation button: Press this button to turn the light on or off. Start by pressing the activation button to access
all of the remote control's functions. Once the light has been activated, only press the activation button again to turn the
light on or off. If the Bluetooth function is activated, this button will not affect it. This speaker has a memory feature as long
as the battery has not completely run down. It remains set to the last lighting mode or colour selected before being turned
off. For example, if the speaker was set to «RED» the last time the light was turned off, it will have the same setting when
you turn it back on. If the battery ran down the last time you used the speaker, this feature won't work. When you press the
activation button after completely recharging the battery, the default mode is «SMOOTH».
4. Bluetooth function activation button: once the speaker has been turned on, the Bluetooth function is automatically
activated. Press this button to turn the Bluetooth function off and, when you listen to music via an AUX cable or flash drive,
press this button to stop the playback. The speaker will then be ready for Bluetooth pairing.
5. Colour selection buttons: Once the light is on, press one of the buttons to select your favourite colour from among
the six colours shown on the remote control.
6. Colour selection button: Once the light is on, press this button to select your 7 favourite colours.
This function is necessary when you want to change the Bluetooth connection and
listening modes from 1 ROCK speaker to 2 ROCKS speakers and vice versa.
• Press the On/Off button located at the bottom of the speaker lamp for 3 seconds..
11