Model Polifix; Changing The Brushes; Model Ellipse And Quadro With Polish Brush Changing The Brushes - Heute Ellipse Originalbetriebsanleitung

Model Polifix-4

Changing the brushes

Place the machine on a suitable substrate on the rear of the
1.
housing.
Remove the polish dispenser cover: To do this use a Phillips
2.
head screwdriver to remove the two screws in the middle (screws
are countered on the rear with nuts ) (Fig. 5).
Use an open-jaw wrench (10 mm) to remove the 4 screws of the
3.
motor carrier on the inside of the rear wall of the housing (Fig. 6).
The respective shaft side can now be made accessible by swin-
4.
ging the motor carrier to the right side or left side (Fig. 7).
Detach the flanges of the individual brushes from the shaft with
5.
an Allen wrench (3 mm) and pull off the brushes.
Slide on the new brushes in the same manner.
6.
Fix the brush flanges in place. In this process ensure that the
7.
fixing screws are again precisely positioned in the respective
shaft receptacle.
Firmly fasten the motor holder on the inside of the rear wall of
8.
the housing with 4 nuts. In this process ensure that the ground
cable is firmly connected to the housing.
Mount the polish dispenser cover.
9.
Fig. 5
Fig. 6
Fig. 7
All manuals and user guides at all-guides.com
Model Ellipse and Quadro with polish brush
Changing the brushes
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Fig. 8
Fig. 9
Fig. 10
Detach the polish dispenser from the holding rail by turning it a
quarter turn (Fig. 1).
Use an Allen wrench (2.5 mm) to remove the cover of the ser-
vice opening on the rear of the machine
(Fig. 8).
In the interior of the opening use an open-end wrench (13 mm)
to unscrew the two nuts of the motor holder on the right approx.
75% (do not unscrew them completely!). Completely unscrew
the two nuts on the left (Fig. 9).
From the front, swing the motor holder in the direction of the po-
lish dispenser, so that the right polishing brush projects forward
and is freely accessible.
Unscrew the Allen stud screws on the brush flange of the
polishing brush with the Allen wrench (3 mm) and pull off the
polishing brush from the side (Fig. 10).
Unscrew the Allen stud screws of the black pre-cleaning brush with
an Allen wrench (2.5 mm) and pull off the pre-cleaning brush.
Slide on the new brushes in the same manner.
Fix the brush flange of the polishing brush or pre-cleaning brush
in place with the Allen stud screws. In this process ensure that
the fixing screws are again precisely positioned in the respective
shaft receptacle.
Use an open-jawed wrench to remove the 4 screws of the motor
carrier on the inside of the rear wall of the housing.
Screw the cover of the service opening back onto the rear side
of the machine.
EN
19