capital sports Evo Nano Bedienungsanleitung Seite 31

Display
CAL
RPM
The individual functions can be called up by pressing the MODE button. Press
and hold the MODE button to reset all values.
Note: If no signal is transmitted from the unit to the console for more than
4 minutes, the console will go into standby mode.
Display indicators in BT mode
When the console is in BT mode, the console displays only the following
values:
Display
TIME
SPEED
DISTANCE
CAL
Description
Counts up to 9999 and then starts counting at 0
again (display range: 0-9999 calories).
Displays the corresponding value as long as the
display receives a signal. If no signal is transmitted
for more than 4 seconds during training, the display
for RPM will show "0" (display range: 0-9999).
Description
Counts the training time up to 99:59 and then starts
counting again at 0:00 (display range: 0:00-99:59
minutes).
Displays training speed (display range: 1.0-22.0
km/h).
Distance covered during training (display range:
0.00-99.99).
Counts up to 9999 and then starts counting again
from 0 (display range: 0-9999 calories).
EN
31