Cleaning And Care; Storage; Troubleshooting; Disposal - Zoofari ZTSK 800 A1 Bedienungs- Und Sicherheitshinweise

Cleaning and care

CAUTION! DANGER TO LIFE BY ELECTRIC
SHOCK! Pull the plug-in mains adapter
of the mains socket before cleaning the product.
Never touch the plug-in mains adapter
moist or wet hands, especially when you plug
it into the socket or pull it out of the socket.
Always keep the plug-in mains adapter
supply cord dry.
CAUTION! RISK OF PROPERTY DAMAGE!
Do not submerge the product in water or any
other liquid to clean it as the product is not
waterproof. This could damage the live parts
(rechargeable batteries).
Do not use any corrosive or abrasive cleaning
agents.
Clean the housing using a damp cloth and a
mild detergent.
Switch the product off by sliding the ON/OFF
switch to the position with the marking "0"
4
is shown.
Disconnect the supply cord from the product
and remove the plug-in mains adapter
the mains socket.
Remove the comb attachment
unit or the paw trimmer unit
1
product (see Fig. F–I).
Wash the comb attachment
or the paw trimmer unit
1
and dry them.
Remove any remaining bits of fur from the
cutting unit using the cleaning brush
1
provided (see Fig. J).
Apply one or two drops of blade oil
between the blades and the moving parts
(see Fig. D + E).
Adjust the length position indicator
2.0 mm after you have finished cleaning the
product, before once more attaching the
cutting unit to the product (see Fig. H + I).
1
Note: Clean the cutting unit
ment and paw trimmer unit
9
14 GB
out
8
with
8
and
8
from
8
, the cutting
9
from the
15
, the cutting unit
9
with running water
15
11
12
to
3
, comb attach-
1
after every use.
15

Storage

Place the product in the travel pouch

Troubleshooting

Error Cause
The product The battery
does not may not be
work. charged.
Trimming is Fur may be
difficult. stuck inside
the blades.
Placing the The length
cutting unit position
or paw indicator is
1
trimmer unit on 0.8, 1.1,
to the 1.4 or
15
product is 1.7 mm.
difficult.
Note: To obtain optimal battery capacity, the product
must be fully charged roughly every 6 months.

Disposal

The packaging is made entirely of recyclable mate-
rials, which you may dispose of at local recycling
facilities.
Observe the marking of the packaging
materials for waste separation, which
b
a
are marked with abbreviations (a) and
numbers (b) with following meaning:
1–7: plastics/20–22: paper and fibre-
board/80–98: composite materials.
The product and packaging materials
are recyclable, dispose of it separately
for better waste treatment. The Triman
logo is valid in France only.
Contact your local refuse disposal
authority for more details of how to
dispose of your worn-out product.
provided.
10
Solution
Recharge the
product.
Clean the cutting
unit and the
1
product and oil it
if necessary.
Adjust the length
position indicator
3 3
to 2.0 mm.