Operation; Changing The Comb Attachments On The Cutting Unit; Setting The Trim Length; Trimming Fur - Zoofari ZTSK 800 A1 Bedienungs- Und Sicherheitshinweise

Charging display
Plug icon turns red and flashes
constantly
Plug icon turns off
Plug icon turns red and flashes
3 times.
Battery-status display
Battery symbol turns red and
flashes
Battery symbol turns red
Battery symbol turns green
To avoid injuries and damage to the product,
always switch the product off by sliding the
ON/OFF switch
4
marking "0" is shown before charging the
battery.
Insert the cable plug of the plug-in mains adapter
into the socket on the lower part of the
8
product .
7
Insert the plug-in mains adapter
which meets the product requirements.
Disconnect the product from the plug-in mains
adapter when the battery-status display
8
shows the red plug icon turns off and the green
battery symbol turns on (i.e. approx. 100 %
battery level).
12 GB
Status
6
Charging is
in progress
Charging is
complete
The battery level
is too low, so
that the product
cannot be
switched on.
Charging is
required.
Status
5
Battery level
is < 15 %. The
product is
operating.
Battery level is
< 15 %. Charg-
ing is in progress.
Battery level is
between 16 %
and 100 %.
The product is
operating or
charging is in
progress.
to the position with the
into a socket
8
Note: Do not leave the product permanently
connected to the plug-in mains adapter
avoid damage to the battery or the product.
Note: You can use the product for up to
approx. 60 minutes with a full battery.

Operation

Changing the comb attachments
on the cutting unit (see Fig. F + G)
Carefully place the desired comb attachment
onto the product as depicted in Fig. F. Ensure
that both recesses of the comb attachment
properly engage into the lateral detents at both
sides above the cutting unit
To remove the comb attachment
slide it forward and upwards using both thumbs.
CAUTION! It is normal that the product will
become hot during use. Occasionally turn off
the product while using and check to see if
product has possibly gotten too hot for your
pet. If so, switch off the product to cool it down.

Setting the trim length

To set different trim lengths, hold the upper
part of the product
position indicator
(0.8–2.0 mm). The set trim length will be dis-
played on the length position indicator
aligns with the dot-marking on the upper part
of the product
Note: Only cutting unit
ments on the trim length. The paw trimmer unit
cannot.
15

Trimming fur

Note: The fur being trimmed should be clean,
5
dry and untangled.
Carefully comb the fur using the supplied styling
comb to disentangle any potential knots.
14
.
1
, press and
9
and twist the length
2
into the desired position
3
.
2
can provide adjust-
1
to
8
9
9
which
3