Description Of The Appliance; Operation; Cleaning And Care - Zoofari ZTSD 36 A1 Bedienungs- Und Sicherheitshinweise

CE- Conformity
This device complies, in regards to conformance with
the basic requirements and other relevent regulations,
with the EMC Directive 2004/108/EC, as well as the
Directive for Low Voltage Devices 2006/95/EC.

Description of the appliance

Appliance (Fig. A)
1 Cutting head
2 Suspension loop
3 On/Off switch
4 Adjustment switch "Cutting length"
Trimming guides and accessories (Fig. B)
1/8" (3 mm Cutting length)
1/4" (6 mm Cutting length)
3/8" (9 mm Cutting length)
1/2" (13 mm Cutting length)
Trimming guide for side step cut (right)
Trimming guide for side step cut (left)
Blade cover
Cleaning brush
Blade oil

Operation

The fur to be cut must be dry and clean. Brush the
fur through to remove any knots.
• Remove the blade guard
head 1 .
• Place the required trimming guide (
with the prongs facing upwards on the cutting
head 1 and thereby press the fl ap of the trim-
ming guide down fi rmly onto the lower metal
edge of the cutting head (see illustration).
• Ensure that the trimming guide has properly
engaged and is secured before starting to cut/
trim the fur.
from the cutting
- )
- 2 -
Note:
It is advisable to fi rst trim a small area so as to test
the individual comb attachments. Start with a comb
attachment for long hair (1/2"
and, if necessary, use a shorter one. The comb
attachments permit cutting lengths from 3 to 13 mm.
• Switch the appliance on by sliding the On/Off
switch 3 to the position „ON".
• Slowly run the appliance through the fur against
the direction of hair growth. Hold the appliance
so that the trimming guide is as fl at as possible
against the animal.
• In addition, with the adjustment switch 4 the
cutting length of the cutter head 1 can be
adjusted in steps (up to 2 mm) without having to
exchange the comb attachment. To do this, slide
the adjustment switch 4 backwards to increase
the cutting length in steps.
With this the cutting length of the respectively
attached comb attachment is also increased by
up to 2 mm.
Slide the adjustment switch 4 forward again to
reduce the cutting length or to bring the comb
attachment back into its original position.
• Through removal of the individual trimming
guide, i.e. using only the cutting head 1 itself,
you can cut clean contours.
• After use, switch the appliance off by sliding the
On/Off switch 3 to the position „OFF".

Cleaning and Care

Risk of electric shock
Before cleaning, remove the plug from the mains
power socket.
NEVER submerse the appliance in water or other
liquids.
• Take the respective trimming guide, if fi tted, off .
• Using exclusively the cleaning brush
the hairs from the cutting head 1 . The cutting
head 1 may not be cleaned with water or
other liquids, except medical alcohol!
• If in regular use, the cutting head 1 should be
oiled occasionally. For this, use the supplied
.
blade oil
• Remove excess oil with a dry cloth.
• Clean the housing with a soft, dry lint-free cloth.
• Store the appliance in a dry and dust free
location. When it is in storage, place the blade
on the cutting head 1 .
guard
or 3/8" )
, remove