Replace Fuse - auna Silverhammer4 Bedienungsanleitung

EN
20

REPLACE FUSE

If the fuse is defective, check the power supply and replace the fuse. If the
fuse blows again, there is probably an internal defect. You should contact
the retailer.
Note: Replace the fuse only with an identical fuse. Never use a fuse with
a higher value, otherwise the appliance may be damaged.
• Before connecting components, disconnect the connection to the
negative terminal of the battery.
• Make sure that the speakers have sufficient capacity.
• The negative speaker cable must not touch the car body. The negative
speaker cables of the left and right speakers must also not be mixed up.
• Route the cables for signal and power supply at a distance from each
other, otherwise interference may occur.
• This high-performance amplifier cannot develop its full power with the
standard speakers.
• If you have a vehicle with standard navigation, the internal memory may
be deleted as soon as you disconnect the negative terminal from the
battery.