MSI K8N SLI Serie Kurzanleitung Seite 35

All manuals and user guides at all-guides.com
[General] 5th level of overclocking, increasing the CPU frequency by 9%.
[Commander] 6th level of overclocking, increasing the CPU frequency by 11%.
MSI Reminds You...
Even though the Dynamic Overclocking Technology is more stable
than manual overclocking, basically, it is still risky. Users are sug-
gested to check their CPU's overclocking capability first. If the PC
appears to be unstable or reboot incidentally, it's better to disable
Dynamic Overclocking or to lower the level of overclocking options.
By the way, if you need to conduct overclocking manually, you also
need to disable Dynamic Overclocking first.
Adjust CPU FSB Frequency
This item allows you to select the CPU Front Side Bus clock frequency (in MHz).
Select the number between [200]~[400] for needed frequency.
HT Frequency
This setting specifies the maximum operating frequency of the link's transmitter clock.
Setting options: [1x], [1.5x], [2x], [2.5x], [3x], [4x], [5x].
HT Width
This field allows you to set the HT W idth between CPU & Chip.↑ mark means Chip to
CPU HT W idth. And ↓ mark means CPU to Chip HT Width. Setting options: [ ↓ 8 ↑ 8], [
↓ 16 ↑ 8], [↓ 8 ↑16], [ ↓16 ↑16].
CPU Spread Spectrum
This setting is used to enable or disable the CPU Spread Spectrum feature. W hen
overclocking the CPU, always set it to [Disabled]. Setting options: [Center Spread],
[Disabled].
SATA Spread Spectrum
This setting is used to enable or disable the SATA Spread Spectrum feature. W hen
overclocking the CPU, always set it to [Disabled]. Setting options: [Disabled], [Down
Spread].
PCIE Spread Spectrum
This setting is used to enable or disable the PCI Express Spread Spectrum feature.
W hen overclocking the CPU, always set it to [Disabled]. Setting options: [Disabled],
[Down Spread].
PCIE Clock
This item allows you to select the PCIE Bus clock frequency (in MHz). Select the
number between [100]~[145] for needed frequency.
SSE/ SSE2 Instructions
This setting disables/enables the SSE/SSE2 Instructions. The Streaming SIMD Exten-
sions (SSE) were introduced in the Pentium III processor. The SSE extensions con-
sist of a new set of instructions and a new set of registers. These instructions and
registers are designed to allow Single-Instruction Multiple-Data (SIMD) computations
to be made on single-precision floating-point numbers.
The Streaming SIMD Extensions 2 (SSE2) were introduced in the Pentium 4 and Intel
Quick User's Guide
E-27