Binding The Transmitter And Receiver; Radio Controller - Modster COMPASS Betriebsanleitung

Manual - MODSTER Compass

Binding the transmitter and receiver

Binding is the process of programming the receiver to recognize the GUID (Globally Unique Identifier)
code of a single specific transmitter.
When a receiver is bound to a transmitter, the receiver will only respond to that specific transmitter.
If you need to rebind for any reason, please follow these steps:
1. With the transmitter switched OFF.
2. Power on the receiver, then turn on the transmitter within 5 seconds.
3. After the receiver LED stop flashing, it means the binding is done.
4. Now you are ready to run.

Radio Controller

The yacht comes with a 2.4G 4-channels radio system. For sailing you will only need 2 channels. Learn
all instructions as below:
1. Sail stick controls maximum expand angle of main sail and jib sail. When you move sail stick in
upper position, both sails will be allowed with larger expand angles when wind comes. Both sails
can expand to left or right depends on wind direction.
2. Rudder stick controls rudder to left or right direction.
3. ail trim / rudder trim allows to adjust neutral position of sail / rudder if needed to center.
No function
Power LED
Sail stick
Sail trim
No function
Power Switch
28
Dual Rate Switch
Rudder stick
No function
Rudder trim
www.modster.at