Installation And Rigging Guide - Modster COMPASS Betriebsanleitung

Manual - MODSTER Compass

Installation and rigging guide

Setup the display base as shown in picture.
Insert the tubes into the sockets, no gluing is
required.
Setup the keel, waterproof rubber piece into
hull by HM5*50mm screw, using a H4.0mm
allen key.
Install the cord holder to hull deck with two
PWA2*10*8mm screws.
22
Fix the keel, waterproof rubber piece and ballast
with a HM5*25mm screw, using a H4.0mm allen
key.
Insert the rudder from hull bottom to deck
through the rudder arm, connected with a clip,
make sure rudder is able to rotate freely. Then
insert push rod through the knob on rudder arm,
keep rudder in center position and tighten the
knob with a H2.0mm allen key.
Insert long mast through main boom, till in
the hull. Ensure the mast screw in the main
boom slot.
www.modster.at