Herunterladen Inhalt Inhalt Diese Seite drucken

Modster COMPASS Betriebsanleitung Seite 26

Quelle: modster.at
Vorschau ausblenden Andere Handbücher für COMPASS:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Manual - MODSTER Compass
Move Silicone Rings to appropriate position as shown in picture.
If further rigging needed, adjust refering to below instruction:
1.
Move SR4 to adjust jib sail until it is appropriately tight, but leaving little bending room so that it can
sail. Normally if in strong wind environment it needs more bending room, in gentle wind
environment it needs less bending room.
2. Move SR5 to adjust the expand angle when you power on and move sail stick. Make sure jib sail is
able to travel larger angle than main sail( normarlly jib sail travels about 90° - 100°, main sail about
80° - 90°). If it is too tight (smaller angle), move SR5 to SR4 direction to increase the angle. If it is too
loose(larger angle), move SR5 to SR6 direction to decrease the angle.
Notice: If need to adjust main sail expand angle, move SR3 to SR2 direction to increase angle, or move
SR3 to mast direction to decrease angle. But normally position of SR3 is preset and no need to adjust.
3. Move SR6 to adjust the Dyneema cord tied in step 24 if it is too tight(move to SR6 direction) or if too
loose(move to SR4 direction), to keep the jib boom with 30mm - 35mm expand distance to mast
when sail stick at lowest position.
4. Move SR7 to adjust distance between jib boom and mast if too close (move to SR6 direction) or if too
far away(Move to counterweight direction) to keep about 5mm - 8mm between jib boom and mast.
5. Rotate counterweight on front of jib boom by clockwise direction to adjust its position, ensuring jib
boom swing CG is located on SR7.
6. Connect three luff rings with main sail and long mast.
26
www.modster.at

Werbung

Kapitel

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

206212

Inhaltsverzeichnis