Modster COMPASS Betriebsanleitung Seite 24

Manual - MODSTER Compass
Cut a length of Dyneema cord
at aroung 100mm, connect
eyelet of main sail and main
boom bearing.
Unleash the Dyneema cord
taped on top of jib sail, tie it to a
clevis through a bowsie.
Cut a length of Dyneema cord
at about 100mm, connect eyelet
on jib sail and SR4 on jib boom.
24
Cut a length of Dyneema cord
at about 150mm, connect eyelet
of main sail and main boom
silicone ring.
Unleash the Dyneema cord
taped on bottom of jib sail, tie it
to the eyelet on jib boom.
Cut a length of Dyneema cord
at about 100mm, connect eyelet
of jib sail and clevis through a
bowsie.
Cut a length of Dyneema cord
at about 1600mm, tie both ends
with a clevis, then hook one side
on eyelet of hull, the other on
backstay crane hole. Connect a
bowsie on cord closer to hull
side.
Cut a length of Dyneema cord
at about 60mm, connect
eyelet on jib sail and eyelet on
jib boom as shown in picture.
Cut a length of Dyneema cord
at about 700mm, tie one end on
the clevis as shown in picture.
www.modster.at