IFM Electronic efector200 OG Bedienungsanleitung Seite 8

Setting of the sensitivity with stationary objects
Activate the programming mode of the unit.
1
Press for about 2s until the LED flashes.
The LED starts to flash rapidly. The unit is in the programming mode
as soon as the LED flashes slowly
Set the sensitivity with object.
2
Press once.
The LED goes out during the first measuring process. As soon as the
LED flashes slowly, the unit is in the programming mode again.
Set the sensitivity without object.
3
Press once.
The LED goes out during the second measuring process.
If the programming was successful, the unit is now in the
normal operating mode.
You can also proceed in reverse order: first setting without the object,
then with the object.
If the setting of the sensitivity is not possible (e.g. object
signal and background signal are about the same), the LED flashes
after step 3 for approx. 2s. The unit then passes into the operating
mode with the sensitivity being unchanged.
8
All manuals and user guides at all-guides.com
receiver
receiver
receiver
transmitter
transmitter
transmitter