Chicco MARSUPIO Go Gebrauchsanleitung Seite 15

1. Fit the baby carrier onto your shoulders by sliding your head
through the crossed shoulder straps (diag. 1).
2. Use the safety clasps to fasten the shoulder straps in place,
as seen in diag. 2 . Check that the safety clasps are fastened
properly on both sides.
3. Adjust the length of the shoulder straps. Hold the ends of
the two side straps and pull them, until they adhere to the
child's body (diag. 3).
4. F or maximum comfort during transport, the shoulder
straps should cross in a central position, slightly below
your shoulder blades (diag. 4).
HOW TO SIT THE CHILD INSIDE THE BABY CARRIER
It is recommended that you place the child in the Baby Carrier
while sitting.
FACING INWARD
5. Place the child inside the baby carrier (diag. 5).
WARNING: Hold your child safely while carrying out this op-
eration. Ensure that the child's legs are positioned correctly,
straddling the seat.
6. Connect the padded strap (l) to the baby carrier shoulder
straps using the buckles (E) fastened to the ends of the
waist strap
Make sure the buckle has been threaded upwards through
the slots and is connected properly (diag.6 A) Use the slot
which is most suitable for your baby's growth phase; make
sure baby's head is resting snugly inside the headrest (B).
Check that the safety clasps are fastened properly (diag.
6C).
7. Use the buckle adjusters ( E ) to obtain a more comfortable
and secure position for your baby (diag. 7). It is also neces-
sary to adjust the child waist strap using the belts (F) so
the baby carrier is never too wide or too tight and adjusted
properly to suit your baby's build (see section 16) .
8. Support the base of the baby carrier to regulate the length
of the shoulder straps one at a time, pulling the belts until
the baby is close up to you and resting upright against your
chest; this will guarantee maximum comfort and safety for
both you and your baby (diag. 8).
FACING FORWARD
When the child is able to keep its head straight and its shoulders
in a vertical position, approximately from four months of age, it
can be transported in a forward facing position.
9. Place the child inside the baby carrier facing forward (diag. 9).
WARNING: Hold your child safely while carrying out this opera-
tion. Ensure that the child's legs are positioned correctly, strad-
dling the seat.
10. Fold the padded strap downwards by 180 degrees (diag. 10A).
11. Connect the padded strap (l) to the baby carrier shoulder
straps using the buckles fastened to the ends of the waist
strap itself (diag. 11). Make sure the buckle has been threaded
upwards through the slots and is connected properly. Use the
slot that most suits your baby's build. Check that the safety
clasps are fastened properly.
12. Use the buckle adjusters ( E ) to obtain a more comfortable
and secure position for your baby (diag. 12A). The child's waist
strap must be adjusted every time it is used Adjust the belts
(F) so the baby carrier is never too wide or too tight and ad-
justed properly to suit your baby's build (see section 16). Ad-
just the length of the lateral width capacity adjuster belts to
guarantee maximum comfort for you and your baby (Diag.
12 B)
13. Support the base of the baby carrier to regulate the length
of the straps, one at a time, pulling the straps until the baby
is close and resting upright against your chest; this will guar-
antee maximum comfort and safety for both you and your
baby (diag. 13).
All manuals and user guides at all-guides.com
HOW TO REMOVE THE CHILD FROM THE BABY CARRIER
It is recommended that you remove the child from the Baby
Carrier while sitting.
14. Hold the child safely and unfasten the buckles located on
15. Remove the child from the baby carrier (diag. 15).
HOW TO ADJUST THE WIDTH AT THE BABY CARRIER
16. The baby carrier also has two practical width capacity ad-
15
both sides of the padded band (diag. 14).
justers to adapt the central section of the carrier so that
it suits a baby's various growth phases. Pull the straps to
adjust the width capacity as seen in diagram 16.