Thermal Cut-Out; Transporting The Appliance; Safety Switch - Silvercrest SKHD 1800 A1 - IAN 74339 Bedienungsanleitung

Bedienung GB Seite 29 Mittwoch, 2. Mai 2012 12:36 12

7.5 Thermal cut-out

For your safety the appliance has a thermal
cut-out.
If the temperature inside the appliance beco-
mes too high, the appliance switches off
automatically:
1. Turn the function selector 1 to
2. Check whether the air inlet or outlet is
obstructed and remove the cause.
If you cannot establish a cause and the
fault occurs repeatedly,
appliance repaired or else take it out of
use.
3. Wait for the appliance to cool down.
4. You can then continue to operate it nor-
mally.

7.6 Safety switch

The appliance is protected against acciden-
tal damage by a safety switch 11 .
The safety switch 11 is located on the bottom
of the appliance and switches the appliance
off immediately should it fall over:
• Return the appliance to an upright posi-
tion. The appliance will switch on again
automatically.
7.7 Frost protection setting
With this function, the appliance prevents
the room temperature falling below the frost
line:
1. Turn the temperature selector 2 to
the frost symbol.
2. Select the low or high heat setting on the
function selector 1 (siehe „7.2 Selecting
functions" auf Seite 28).
SKHD 1800 A1
7.8 Fan function
1. Select the fan function
selector 1 .
2. Set the temperature selector 2 to "MAX".

7.9 Transporting the appliance

.
If you wish to transport the apliance, always
carry it by the lift-up carry handle 4 .
have the
on the function
29