Panasonic EY4550 Bedienungsanleitung Seite 12

Position of base and purpose of use
Base adjustment
Purpose of use
hole position
Normal right-angled
cutting
Cutting at an angle
between 0° and 45°
NOTE:
This is only a rough guide. The
actual angle of the cut will be
affected by factors such as the way
the tool is held against the surface.
All manuals and user guides at all-guides.com
Adjusting the orbital stroke mode
Lever
position
- 12 -
• Adjust the orbital stroke mode to the
object to be cut.
Blade
movement
• Cutting hard
• Smooth cutting of
0
• Cutting around
Vertical only
• Cutting softer
1
• Cutting hardwood,
Low orbital stroke
mode
• Cutting fairly soft
• Cutting wood and
2
• High-speed
Medium orbital
stroke mode
• Cutting soft
• High-speed
3
High orbital
stroke mode
• If you would like to produce a cleaner
finish, set the orbital stroke mode to
a lower level.
3
2
1
Main
applications
metals such as
steel
building materials
and plywood
boards
small curves
metals such as
aluminum and
other non-ferrous
metals
plywood boards
and plastics
materials
composite boards
cutting of
aluminum and soft
steel
materials
cutting of
materials such as
wood, composite
boards and
plastics