Adjusting The Base - Panasonic EY4550 Bedienungsanleitung

4. • Insert the blade into the blade
clamp bracket and set the back of
the blade along the roller guide so
that the back of the jigsaw blade
slides along the roller guide.
• Make sure the sten of blade is
deep enough inserted until the
blade projection is fixed by blade
clamp.
5. Release the blade Attach/Remove
lever.
• Check that the back of blade is along
the roller guide and set straight.
WARNING:
If you do not insert the saw blade
deep enough, the saw blade may be
ejected unexpectedly
operation. This can be extremely
dangerous.
Removal
1. Pull the blade Attach/Remove lever.
2. Pull out the blade.

Adjusting the base

1. Use the hex wrench to loosen the
base fixing screw.
All manuals and user guides at all-guides.com
2. Move the base along the base
Roller guide
during
- 11 -
adjustment hole to set its position.
(See the diagram at right.)
• The base can be adjusted to between
0° and 45° sideways and the
forward/back position can also be
adjusted. If tilting the base sideways,
remove the dust cover first.
• Refer to the bevel index to determine
the angle.
• Rip fence fixing screw should be
located on the opposite side tool is
beveled.
3. Use the hex wrench to tighten the
base fixing screw.