Power Supply Unit Plug; Storage And Winter Break - Viking MI 632 Gebrauchsanleitung

● In the "Service" menu, select the "Find
wire break" entry and confirm OK.
( 10.16)
Searching with control panel removed:
Starting at the docking station, follow the
edge of the mowing area clockwise with
the robotic mower (1). Steer the machine
using the control pad for this purpose and
ensure that the perimeter wire (2) runs
under the wire sensor. The wire sensors
are installed in a protected position on the
left and right at the front of the robotic
mower.
During the wire break search, the signal
strength is indicated in the display; the
wire sensors are in the ideal position
above the perimeter wire when this value
is at its highest.
The Wire signal OK symbol
appears in the display when the
wire sensors are correctly
receiving the wire signal.
122
All manuals and user guides at all-guides.com
In the area of the wire break, the
signal strength drops and the
Check wire signal symbol
appears in the display.
● Bridge the break with the aid of a wire
connector ( 11.12). If necessary, re-
route the perimeter wire in the area of
the break.
● Press the ON/OFF button on the
docking station. Once the wire
break has been correctly
rectified, the red LED illuminates.
( 12.1)
Fine search with control panel inserted:
Lift the robotic mower slightly by the
carrying handle (1) and unload the drive
wheels. Push the machine, resting on its
front wheels and follow the perimeter
wire (2).
The further procedure corresponds to the
search with the control panel removed.

15.7 Power supply unit plug

The power supply unit is equipped with a
removable plug.
This plug can be removed if the power
supply unit is installed inside a building
and therefore the power cable must be
routed through a hole in the wall.
Risk of injury!
Disconnect the mains plug and
unplug the power supply unit from
the docking station before
performing any work on the power
supply unit.
Read the instructions in the section
"Warning – dangers caused by
electrical current". (
Install the blue cable (BL) and the brown
cable (BR) in the plug as illustrated.
Tighten screws (1).

15.8 Storage and winter break

Note the following points when storing the
robotic mower for long periods (e.g. winter
break):
● Charge the battery ( 14.8)
● Switch off automatic mowing (
● Activate the highest safety level (anti-
theft alarm) ( 10.15)
● Activate the disabling device (
0478 131 9920 C - EN
6.3)
10.4)
5.2)