Inhaltsverzeichnis
Werbung
5. INSPECTION AND MAINTENANCE INSTRUCTIONS
The high-lift pallet truck, with forks for independent lifting of loads, is intended
for on-site transporting of unit loads, e.g. in warehouses associated with industry
and delivery companies etc., for short range transporting of standard and wire
mesh pallets as well as other palletised loads.
Additionally, the high-lift pallet truck can be made stationary as a working
platform. (Automatic supports are placed once a lift of 400 mm is reached).
It is not suitable for use in potentially .
6. LOADING DIAGRAM
The load center must not be exceeded.
Danger of Tipping over!
The load must be evenly distributed across both prongs of the forks.
600mm
7. BATTERY AND CHARGER
Battery voltage
Max charging current of charger
Input/Output voltage of charger
Recommendations for security in relation with the acid of the battery. The pallet
truck should be put out of function before working on the battery.
Service people:
Read carefully the instructions of use and maintenance, given by the company
manufacturing the battery.
Maintenance of the battery:
Be sure pole terminals and cable lug of battery are clean and covered slightly
with grease and tightened.
Do not retain discharged batteries. Recharge as soon as possible.
Avoid heavy discharge of more than 80% of nominal capacity.
Disposal of the battery:
Please follow carefully national laws and recommendations concerning
protection of environment of your country. Also follow battery manufacturer
recommendations on this purpose.
12V / 70Ah
8A
AC220V / DC 12V
3 | 01-2811700 • ajproducts.ie
Battery loading
Battery should be loaded as soon as lifting speed is slowing down, and/or
green diode is dark. The loading is starting automatically, the red
diode is on.
The loading is finished when 8 to 10 diodes (including the red diode) of the
discharge indicator is on. When loading is done the green pilot lamp is on.
The electric high-lift pallet truck can be taken into operation again.
The loading time is about 10 to 12 hours while the machine cannot be used.
Never leave the built-in charger longer than 24 hours connected. Never
discharge the battery totally (max. discharge 80%), this could damage the
battery or even render it useless.
Safety warning
Before inspection andmaintenance work is carried out, appropriate
measures should be taken to remove all loads from the electric high-lift
pallet truck.
Maintenance and inspection work
Check operating elements for fault-
less operation.
Check condition of the travelling rol-
lers and roller axles
Grease joints and bearings
Check functioning of wheels and
rollers
Check hydraulic system for leakage
(Is the top lifting height
reached effortlessly?)
Check the set-up of the drain valve
Check all screw and bolt connections
for tightness
Check all parts of the pallet truck for
wear and replace defective
parts where necessary
Change oil in the hydraulic system
Check readability of type plate.
Authorize inspection by competent
technical expert
The service life of your high-lift pallet truck is limited.
Worn parts must be renewed in adequate time.
8. OIL AND LUBRICANT RECOMMENDATIONS
Hydraulic oil: ISO VG 46
Lubricant: Multipurpose lubricating grease for example: ARAL Aralub 2, BP
Multipurpose lubricating grease L2, Energrease LS 2, ESSO Beacon 2
The oil level should be checked every six months. The following oil types are to
be used depending on the temperature conditions.
Temperature
Oil
-5°C – approx. +45° C
L-HL 68 Hydraulic oil (equivalent to ISO
-15°C - approx. - 5° C
L-HL 46 Hydraulic oil (equivalent to ISO
Waste oil must be disposed of in accordance with legal provisions!
Inspection intervals
Daily or each time before use
Monthly
Every 3 months
Annually
VG68)
VG46)
Werbung
Inhaltsverzeichnis
