FLASHFORGE 3D PRINTER Creator 3 Pro Schnellstartanleitung Seite 9

The equipment has been leveled and calibrated before leaving factory. However, the
leveling plane may be damaged due to the vibration generated during transportation. It
is recommended to perform leveling before the first printing. There are two leveling
modes: auxiliary leveling mode and manual leveling mode. In the auxiliary leveling
mode, all execution will be completed with the help of the extruder sensor and auxiliary
prompts. When the function option is in the manual mode, the platform leveling in the
auxiliary mode will not activate the sensor function.
In total, the equipment contains the following leveling calibrations: Platform Leveling,
Calibration XY, Calibration Z and Auto level;
Please operate in the following order:
1. Click [Tools] and [Level Calibration] on the touch screen;
2. Select the auxiliary mode for leveling and calibration;
3. The extruder sensor calibration has been set before leaving factory, so there is no need
to operate again; Click platform leveling and operate following the prompts on the
screen;
4. Perform Z-axis calibration and operate following the prompts on the screen;
5. The X, Y axis have been calibrated before leaving factory, so there is no need to
operate again;
6. The whole leveling and calibration is completed.
9-point leveling function: when the printing flatness is still poor after the platform
leveling and XY/Z axis calibration, this function can be used to compensate for better
flatness;
Manual leveling mode: Execute platform leveling, Z-axis calibration and X, Y axis
calibration in turn. This is a complete set of leveling and calibration operation procedures.
Leveling and Calibration
07