Appliance Equipment; Installation - BOMANN GS 7326.1 Bedienungsanleitung, Garantie

 To prevent hazards, check the appliance for any
transport damage.
 In case of damage, do not put the appliance into
operation. Contact your distributor.
NOTE:
Production residue or dust may have collected on the
appliance. We recommend cleaning the appliance
according to chapter "Cleaning and Maintenance".

Appliance Equipment

Appliance overview
Delivery scope
5x freezing drawer, 1x freezing flap, 1x ice-cube tray,
1x door handle incl. fixing screws with covers,
(reversing the door opening)
1x hinge cover

Installation

Conditions for the installation location
 Good ventilation is required around the appliance
to dissipate the heat properly and to guarantee ef-
ficient cooling operation at low power consump-
tion. Enough clearance is necessary.
- Gap to the back approx. 50～70 mm, to the
side walls and above the device each approx.
min. 100 mm;
- Place the appliance so that the appliance door
can open without being impeded.
All manuals and user guides at all-guides.com
1 Control panel
2 Freezing compart-
ment with flap
3 Freezing drawers
4 Feet
5 Door handle
 Only install at a location with an ambient tempera-
ture suitable for the climate class of the appliance.
The climate class can be found under "Technical
Data" and on the rating label located in the interior
or on the appliance rear.
 Place the appliance on a steady and safe surface.
If the appliance is not horizontally leveled, adjust
the feet accordingly.
 Avoid the installation:
- near heaters, next to a stove, direct sunlight or
any other heat sources;
- at locations with high humidity (e.g. outdoors,
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
- near volatile or flammable materials (e.g. gas,
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
- Do not expose the appliance any weather.
Assembling the door handle
Remove the cover caps from the door outer side and
tighten the handle with the delivered screws into the
underlying holes. Put the included screw covers on.
Electrical connection
WARNING:
 The installation to the mains supply must conform
to the local standards and regulations.
 Improper connection may cause to an electric
shock!
18