AsViva EKC5 Betriebsanleitung Seite 37

ASSEMBLY
ATTACH THE FRONT WHEELS
5
6
Remove all parts from the front axle.
1. Slide a washer Ø12 onto the front axle.
2. Slide the front wheel onto the front axle.
3. Fix the wheel with a Ø12 washer and a lock nut which you also place on the rear axle.
4. Tighten them with a wrench.
5. Insert the split pin into the hole at the end of the front axle. Bend back the ends of the split pin with
needle nose pliers (not included).
6. Finally, clip / snap on the hupcap.
Now repeat the work steps on the other side of the vehicle body.
GAP
3
4
After assembling any wheel to the axles, please check the
gap between the screw thread and the collapsible (refer to
below picture), if the gap is too big, please add two or three
washers inside the wheel, but after tightening the nut outside
the wheel, please turn the wheel by your finger to check if the
wheel can run smoothly, this is very important, because if the
wheel can run smoothly, it is ok, but if the nut press the wheel
and the wheel can't run smoothly, the motor will be broken
easily! Then you need to decrease one or two washers to
make sure the wheel can run smoothly!
2
1
Front Bottom View
37