AsViva EKC5 Betriebsanleitung Seite 35

ASSEMBLY
ATTACH THE DRIVE WHEELS
4
5
1. Slide the drive wheel onto the rear axle. Make sure that it is aligned with the gear box.
2. Fix the wheel with a Ø12 washer and a lock nut by placing it on the rear axle.
3. Tighten them with a wrench.
[HINT: An extra wrench is provided to hold the lock nut on the other side of the rear
axle while you tighten the lock nut on the other side].
4. Insert the split pin into the hole at the end of the rear axle. Bend the ends of the split pin back with
needle nose pliers (not included).
5. Finally, snap/clip on the hubcaps.
Now repeat the work steps on the other side of the vehicle body.
2
3
1
35