AsViva EKC5 Betriebsanleitung Seite 36

ASSEMBLY
ATTACH THE FRONT AXLE
7-1
Steering column
Front axle plate
Front Bottom View
Cut off the plastic tie on the front axle with scissors.
7-1. Adjust the front axle plate so that the axle is in the correct position as shown.
7-2.
- Insert the M6x16 machine screw through the hole in the steering linkage
- Place the Ø6 washer in between on the hole in the front axle plate.
- Make sure the steering linkage is seated over the front axle plate as shown
- Attach the Ø6 lock nut and tighten it securely.
36
Steering linkage
M6x16 machine screw
7-2
Steering linkage
Ø6
washer
Ø6 lock nut
Front axle plate