Zone Parameters - Airzone Easyzone AZEZ6DAIST07 Kurzanleitung

ZONE PARAMETERS

Note: Some parameters may vary depending on your system.
•
Associated outputs. This displays and allows you to select the control outputs associated to
the thermostat.
•
Thermostat settings. This allows you to set up a thermostat as Master or Zone.
*Note: It cannot be configured as Master if there is already another thermostat configured
as such.
•
Use mode. This allows you to configure the thermostat for the system's different zones
in Basic or Advanced mode. By default, it is set to Advanced. The parameters that can be
controlled in Basic mode are:
- On/Off.
- Set-point temperature.
- Operation mode (only if this is the master thermostat).
- Fan speed.
If you need to reset the thermostat to Advanced mode, access the Advanced settings menu
and activate Advanced use mode.
•
Control stages. (Only available in installations with AZCE6OUTPUT8 modules). This allows
you to configure the heating and cooling stages in the selected zone or all zones in the
system. The options to configure are:
- Air: Enables heating/cooling by air in the zone selected.
- Radiant (not available in cooling stages): Enables radiant heating in the zone selected.
- Combined (not available in cooling stages): Enables air and radiant heating in the selected
zone and allows the user to select the heating stage desired in that zone: Air, Radiant or
Combined (see Zone settings section on the Blueface thermostat, Heating stages).
- Off: Disables the heating/cooling stage in the zone selected.
•
Offset. This allows you to correct the room temperature measured in the different zones or
in all of them, due to deviations produced by sources of heat/cold nearby, with a correction
factor between -2.5°C and 2.5°C in steps of 0.5°C. By default, it is set to 0°C.
•
Reset thermostat. (Not available in remote zones). This allows you to reset the thermostat
by returning to the initial settings menu.
EN
19