Other Peripherals; Power Supply To The System; Reset The System; Change Of Battery - Airzone Easyzone AZEZ6DAIST07 Kurzanleitung

Other peripherals

Follow the instructions on their technical data sheet.
Important: For elements with external power supply at 110/230 VAC, it is only necessary to
connect poles "A" and "B" of the bus for communications.

Power supply to the system

Use power supply input to power the main control
board at 110/230 VAC as well as any other control
elements that require external power supply. Use
3x1.5 mm² cable. To supply power to the main control
board, loosen the cable gland if necessary, insert the
cable through the hole (Ø: 5 -10 mm) and attach the
cables to the terminal following the polarity indicated.
Connect the terminal to the power supply input and
tighten the cable gland to attach the power supply
cable.
The connection to the external power supply
must include a main switch or other method of
disconnection that includes a constant separation
for all polarities, in accordance with appropriate
local and national regulations. The system will
automatically restart if the power supply is turned
off. Use separate circuits for the unit that is to be
controlled and the power supply to the system.
Once all the connections have been made, make
sure the cover of the main control board is correctly
replaced.

RESET THE SYSTEM

If you want to return to factory values, press and hold SW1 until LED D19 stops
flashing. Wait for the LEDS to go back to their normal state before starting
with the initial configuration process.

CHANGE OF BATTERY

To replace the battery, separate the thermostat
from its base and replace the battery (CR2450).
Important: The use of batteries from leading
brands is recommended, similar to those provided.
A battery of lesser quality may have a reduced life.
Remember to place the
appropriate recycling bin.
Note: Remember to remove the anti-vandalism
system (if installed)
thermostat from the wall.
old battery in an
before removing the
EN
9