Installation And Connection - Renkforce 751624 Bedienungsanleitung

8. Installation and connection

8.1 Installation
The code lock is suitable for outdoor use (IP65).
The connection cables must not be kinked or squashed. This can result in mal-
functions, short circuits and defects in the device.
Make sure that cables or wires are not damaged when drilling or bolting in place.
• Detach the housing cover on the back of the code lock by removing the screw on the under-
side of the housing. A corresponding tool is supplied with the device.
• There are four round markings on the inside of the housing cover. Make corresponding drill
holes using a 3.5-4 mm metal drill bit.
• Another hole for the connection cable (depending on diameter) must be drilled into the
centre of the housing.
• Attach the code lock with suitable installation material to an even, vertical and vibration- free
surface.
23