Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
II.
Using your power-assisted bicycle
This power-assisted bicycle can be used with or without
assistance.
Once activated, the power assistance works as soon as you
pedal forward. The operating principle is based on a torque
sensor which, as soon as the pedal is pressed, activates the
power assistance. So, the harder it is pressed, the greater the
assistance.
However, please note that the assistance varies according to
the speed of the bicycle:
-
it is high when starting,
-
less high when the bicycle is in movement,
-
then above 25 km/h, the assistance cuts out. It will
automatically resume when the speed is lower. You can
go faster, but you will have to do it on your own, without
any power assistance.
a) Display and control unit
No.
Element
1
Display
2
ON/OFF button
3
+ / - buttons
To activate the assistance, press the "ON/OFF" button
the display once. To deactivate it, hold down the ON/OFF
button for a few seconds. After a certain period of inactivity,
the display is switched off to save energy.
In the event of a breakdown, various error codes are displayed.
When an error code is displayed, first restart the system
following the solution suggested in the table below.
If the problem persists or if another code appears, please
contact your retailer.
Code
Problem
7
Overvoltage problem
10
The temperature in
the motor has
reached its maximum
protective value
14
The temperature in
the controller has
reached its maximum
protective value
21
Speed sensor error
Function
View assistance information
Stop/Start assistance
Increase / Decrease
on
Solution
Remove the battery, then
reinsert it. If the problem
persists, contact your
retailer.
Turn off the system and let
it cool down. If the
problem persists, contact
your retailer.
Turn off the system and let
it cool down. If the
problem persists, contact
your retailer.
Restart the system. Then
check that the magnet
attached to the spoke is
aligned with the speed
sensor and that the
distance is between 10
and 20 mm. Then check
that the speed sensor
Code
Problem
30
Connection problem
33
Brake signal error
b) Symbols and indicators
The display includes the following elements.
Briefly press the ON/OFF button to scroll through the usage
data.
No.
Description
1
Battery level display
2
Assistance mode selected
3
Lighting activation
4
Gears
5
Speed
6
Usage data
TRIP: daily kilometres
ODO: total number of kilometres
MAX: maximum speed
AVG: average speed
RANGE: remaining distance
CALORIES: energy consumption
POWER: output power
TIME: journey time
Service: displayed every 5,000 km
Indicator
Red indicator light
Green indicator light
Blue indicator light
When the light is red, the battery must be recharged before the
bicycle can be used. Refer to the battery section for how to
charge.
17/90
Solution
connector is properly
connected. If the problem
persists, contact your
retailer.
Check that all connections
are correct. If the problem
persists, contact your
retailer.
Check all connectors. If the
problem persists, contact
your retailer.
Press the battery ON/OFF button at
any time to view the battery charge.
Charge level
5 % to 30 %
30 % to 60 %
60 % to 100 %
Werbung
Inhaltsverzeichnis
