Makita DHP482RTEB Betriebsanleitung Seite 8

1. Reversing switch lever
CAUTION:
Always check the direction of
rotation before operation.
CAUTION:
the tool comes to a complete stop. Changing the
age the tool.
CAUTION:
tral position.
of rotation. Depress the reversing switch lever from the
terclockwise rotation.
When the reversing switch lever is in the neutral posi-
1. Speed change lever
CAUTION:
fully to the correct position. If you operate the
tool with the speed change lever positioned halfway
damaged.
CAUTION:
Position of Speed
speed
1 Low
2 High
1.
ring 3. Graduation 4.
Machine screw
Wood Soft wood
screw (e.g. pine)
Hard wood
(e.g. lauan)
Applicable
operation
High Heavy load-
ing operation
Low Light loading
operation
2.
1 2 3 4 5
M4
–
–
torque. Be sure that the speed change lever is set to the
If the tool speed is coming down extremely during the
the operation.
-
CAUTION:
your desired mode mark. If you operate the tool
-
CAUTION:
from "
-
at the "
1.
ring 3. Graduation 4.
• Drilling mode (rotation only)
• Hammer drilling mode (rotation with
hammering)
• Screwdriving mode (rotation with clutch)
action mode changing ring and align the mark that you
fastening torque at 1 and maximum torque at 21.
Before actual operation, drive a trial screw into your
material or a piece of duplicate material to determine
which torque level is required for a particular applica-
8 11 12
M5
3.5 x 22 4.1x 38
3.5 x 22
8 ENGLISH
2.
13 14 15 18
M6
–
4.1x 38
-
-
21
–