Hardware - Gerdes Primux Installationsanleitung

Hardware

Preparation
TE/NT setting
On the NT-Mode versions of the PrimuX controllers all ports can be independently configured
for TE or NT mode. Initially all ports are configured for TE mode. On the PrimuX S2M controllers
the configuration is switched by simply turning the configuration plug around. With the PrimuX
S0 controllers additional NT plugs are provided. These NT plugs replace the already configured
TE plugs for those ports you want to use in NT mode:
Remove the TE mode configuration plug (use a small screwdriver)
Insert an NT mode configuration plug into the slot...
Hardware 35