Troubleshooting - Krups OPIO STEAM & PUMP XP320840 Bedienungsanleitung

TROUBLESHOOTING

PROBLEMS POSSIBLE CAUSES
The coffee is very moist. You have not used enough
coffee.
The espresso flows too The coffee is too fine, too
slowly. coarse or too mealy.
The filter holder is dirty.
The head of the filter holder
is clogged.
Your machine is calcified.
There is too much coffee.
A continuous flow of water Your machine is becoming
pours from the filter holder calcified because the water
after making an espresso. is particularly hard.
The red cap was not
removed.
A continuous flow of water Your machine is becoming
pours from the filter holder calcified because the water
after making an espresso. is particularly hard.
Coffee grounds are present The filter holder is clogged.
in the cup.
The coffee grounds are too
fine.
The seal on the head of the
filter holder is clogged.
8
SOLUTIONS
Add more coffee.
Choose slightly larger
coffee grounds.
Clean your filter holder
using the instructions in the
section: CLEANING AND
MAINTENANCE - B. Filter
holder. Clean the coffee
filter as well.
When the appliance has
cooled, clean the grill
through which the water
flows using a damp sponge.
Descale your machine
following the user
instructions provided.
Observe the maximum
limits when filling the filter.
Descale your machine
immediately following the
user instructions provided.
Remove the red cap.
Descale your machine
immediately following the
user instructions provided.
Clean the filter holder using
hot water.
Use slightly larger coffee
grounds.
Clean the filter holder
and the seal with a damp
sponge.
PROBLEMS POSSIBLE CAUSES
The espresso is not frothy. The coffee grounds are too
old.
The ground coffee is
not suitable for making
espresso.
There is too little coffee in
the filter holder.
The water tank leaks when The valve at the bottom
it is moved. of the tank is dirty or
defective.
The valve is blocked by the
calcified deposits.
Water leak beneath the There is an internal leak.
appliance.
The pump is abnormally No water in the tank.
noisy.
The espresso leaks out the The filter holder is not
sides of the filter holder. positioned correctly.
The edge of the filter holder
is clogged by the coffee.
Your espresso tastes bad. After descaling, the rinsing
cycle was not carried out
correctly.
SOLUTIONS
Use freshly ground coffee.
Use finer grounds.
Add more coffee.
Wash the water tank and
operate the valve with your
finger, which is beneath the
tank.
Descale your machine
following the user
instructions provided.
Check that the tank is
positioned correctly. If
the problem persists, do
not use the appliance and
consult an approved service
centre.
Fill the water tank and
restart the pump (refer to
the section: FIRST USE).
Avoid emptying the tank
completely.
Fit the filter holder in
position and lock it (turn
from left to right until it
stops).
Remove any excess coffee
that prevents you from fully
locking the filter holder.
Remove the excess coffee
and clean the grill through
which the water flows using
a damp sponge.
Rinse the appliance in line
with the user instructions
and check the quality of the
coffee.
9